VStabi Pioneer of Flybarless

The VBar software has two modes: The flight menu and the Programming Assistant (Setup Wizard).

You will use the flight menu to select your preferred flying style and adjust the gain of your model. Tail gain is set via the gyro channel of your transmitter

The Programming Assistant (Setup Wizard) leads you to a finished setup in 11 consecutive steps. You must read and follow the short explanations supplied at each step. In several places you have the option of clicking on buttons showing a little book with a question mark. These buttons lead you to the www.vstabi.info website where you will find additional relevant information. Also, by hovering the cursor over a button, you can find additional online information.

You can move around in the setup menu by clicking “Continue” and “Back.” You cannot click on the individual tabs.

Careful: Should you want to create a new setup, disconnect the motor / speed controller first in order to avoid unwanted powering up! This is necessary because after clicking on “Create New Setup”, all values will be reset, and you have to begin from scratch. The reset also applies