Startseite › VBar Control EN › VBar Control Manual

Plane Manual

Before getting started with VPlane the following preparations must be done:

  • install the VPlane App on your VBar Control. This must be done through our App Store together with the VBar Control manager and the online update procedure.
  • install the VPlane firmware on the VBar you want to use. This will be done similar to a V6 heli installation under usage of the 5.3 pc software. The VPlane can be self-enabled of course. If the VBar has already a V6 loaded - the recovery porcedure must be done previously.

As soon as a VBar will be connected to VBar control it will be identified and the right apps (Heli or Plane) will be loaded. Also possible extension apps will be loaded too.

 

Functions with use of a Mini VBar:

  • 1 Elevator servo (or V-Mix)
  • 1 Rudder servo (or V-Mix)
  • 2 Aileron servos (or Deltamix)
  • 1 Throttle output

 

Functions with use of a Standard VBar:

  • 1 Elevator servo (or V-Mix)
  • 1 Rudder servo (or V-Mix)
  • 2 Aileron servos (or Deltamix)
  • 1 Throttle output
  • 1 more elevator servo (not with flaps)
  • 2 Flap servos (not with second elevator servo)
  • AUX function - Poti 1 to elevator socket (fixed, can be set up with Pro Aux App)
  • AUX function - Poti 2 to aileron socket (fixed, can be set up with Pro Aux App)
  • AUX function - Option switch 1 to rudder socket (fixed, can be set up with Pro Aux App)

 

Please unplug motor cables during any setup procedures to avoid unintentioned injuries from rotating props.

Unplug the servos during the basic setup until they will be used. This avoids unintended mechanical bindings during setup.

For general descriptions about the VBar Control system like switch assignments etc. - please read the VBar Control Device Manual.