English
DeutschSingle Line
Single Line Receiver
In Single Line Mode, all inputs including the potis and switches are mapped to a channel on the single line protocol. Depending on the used protocol this allowes to transmit most of the raw channels.
In VBasic the Single Line Output is connected to the macrocell subsystem, so the macrocells are programmed to do this task. In this mode the Output Channels are not used, but they still may be programmed to output something.
There are supported 5 different output Protocols:
| Name | Protocol | Channels | Updaterate |
| S Bus | Futaba S Bus | 16 | 14ms |
| UDI | Universal Digital Input (here used as Output) | 12 | 10ms |
| Spek | Simulate Spektrum Sat Signal (Appears at AUX1, not on the Tele Sockets!) | 7 | 20ms |
| PPM8 | 8 Channel PPM | 8 | 18ms |
| PPM12 | 12 Channel PPM | 12 | 24ms |
It is possible to change the default update rates, but it is not guaranteed, that the new rate will work correctly with the target unit.
Channel Assignment for the serial channels. Depending on the used protocol, only the numbered channels are output. All assignments can be changed freely in the macrocell setup.
| Channel | Description | S Bus | UDI | Spek | PPM8 | PPM12 |
| 1 | Flight Control Aileron | x | x | x | x | x |
| 2 | Flight Control Elevator | x | x | x | x | x |
| 3 | Flight Control Tail | x | x | x | x | x |
| 4 | Throttle Stick (Raw Stick Input) | x | x | x | x | x |
| 5 | Throttle Output (Throttle after Idle offsets and failsafe) | x | x | x | x | x |
| 6 | Pot 1 | x | x | x | x | x |
| 7 | Pot 2 | x | x | x | x | x |
| 8 | Motor Switch | x | x | x | x | |
| 9 | Bank Switch | x | x | x | ||
| 10 | Buddy Switch | x | x | x | ||
| 11 | Option 1 Switch | x | x | x | ||
| 12 | Option 2 Switch | x | x | x | ||
| 13 | Option 3 Switch | x | ||||
| 14 | Not Used | x | ||||
| 15 | Not Used | x | ||||
| 16 | Not Used | x |
Diagram how the signal is routet through the blocks in single line mode
