English
DeutschMiscellaneous
Which receivers can be used with a VBar with version 5?
Standard RX
Each function has a seperate output on the RX. The RX decodes the complete recieved digital signal and encodes a PWM signal for each function. So each function needs a seperate signal lead to our VStabi. The function signals can output with up to 7 ms (Futaba HS) pulse rate for every single signal, 20 ms is standard. The signals are analog PWM signals. Every analog signal has to be measured in it's pulse length by VStabi to determine the stick position of the TX. (Available for every Standard RX in the world).
Single line RX
A RX with only 1 lead for signal output. The RX decodes the complete received digital signal and encodes a PWM signal for each function. Now they will be appended to one complete analog PWM signal chain. The signals are "all in a row" as on a rc-buddybox-systems. So one complete signal row contains every analog PWM signal of every function and a sync signal also. That is the reason why this data management will always be slower than standart above. Every analog signal has to be measured in it's pulse length by VStabi to determine the stick position of the TX. Also VStabi has to watch for the sync to start with the right signal decoding ... (Available for e.g. Jeti and Futaba). To use with Jeti, set the RX to 20 ms and computed with a Jeti Box.
Satellite RX
A fully digital data protocoll will be sent out from this RX to VStabi. No PWM encoding/decoding necessary, the signal can be used immediately without any decoding in our unit. Much faster than the 2 signal managements above. (Available for Spektrum Satellites, with DSM2 / DSMX).
S-Bus RX, Graupner HoTT, JR XBus Mode.B and Jeti M-Link (UDI)
A fully digital data protocoll will be sent out from this RX to VBar after decoding by the RX (Futaba S-Bus)
The online update failed—VBar not operable
A possible error occured during the update, mostly caused by the USB connections.
If you have either a mini VBar or a Standard VBar with black, blue or silverline plastic sensor we got a solution here. Using a old silver full metal sensor case please contact us by forum or mail.
Please do this steps:
- Download the recovery firmware in the link below
- unzip it on your harddrive
- connect VBar and pc
- start pc software
- in pc soft select File—Firmware Upload
- select the .urec file on your harddrive
- only now turn on the RC power
The Upload should start now. Please take note that this firmware is a non-flyable version. It is necessary to redo the online update again after this step has finished.
Download the recovery file here