VStabi Pioneer of Flybarless

Please note that the governor will active itself above 600 RPM Headspeed when a valid preset RPM signal is given by TX. Using the governor with a normal throttle curve from TX starting at idle (rotor nearly stopped) up to full throttle should be done as following here:

Define a switch where you can switch off the governor aon your TX. Most TX have a preconfigured switch (e.g. a T8) you can use for this. At the first spoolup disable the governor by this switch, spool up the heli manually to more than 600 RPM and turn the governor on after you have passed this headspeed.

Governor Mode:
After activating the Nitro mode click on the reset button to set our default values to the Vbar.

Throttle input channel from receiver:
Set as needed. The additional text in the dropdown will show you the current channel assignments for your assistance.

Preset channel from reciever:
Set as needed. The additional text in the dropdown will show you the current channel assignments for your assistance.

Output socket on VBar:
Set as needed. Take note that the Servo socket near the sensor socket has only a limited power lead. So it is forbidden to use this as power source input. You can also choose Servo 4 (not with 4 swash servos) or Collective (not with standard RX hookup).