Wiring your Mini VBar

 

Pay attention when connecting the USB wire: Do not short circuit the connector for the Control Panel/Bluetooth Module!

Bluetooth-PIN: 1111

Connection of servos, devices:

RD = Tail rotor servo
Ch1 ... 3 = Swashplate servos
RX A = triple I/O connector
RX B = single I/O and power supply
RX C = single I/O and power supply
RX 1 = Spektrum satellite 1
RX 2 = Spektrum satellite 2
CP = Control panel or bluetooth, marked lead towards the "CP"

 

Connectors on the pinning side:

RX A = triple I/O, do not use for RC voltage!
All others: brown/black wire pointing towards the upper (label) side.

 

Connectors for standard reciever:

RD = Tail rotor servo
Ch1 ... 3 = Swashplate servos
RX A = Aileron, elevator and rudder signal from RX
RX B = Collective RX signal and power supply
RX C = Gyro gain RX signal and power supply
RX 1 = not used
RX 2 = not used
 

 

Connectors for single line (Jeti, Futaba RASST, Graupner HOTT) and Futaba S-Bus as well as Multiplex M-Link:

RD = Tail rotor servo
Ch1 ... 3 = Swashplate servos
RX A = not used
RX B = ESC signal output
RX C = RX signal input
RX 1 = not used
RX 2 = not used
 

 

Connectors for Spektrum satellites:

RD = Tail rotor servo
Ch1 ... 3 = Swashplate servos
RX A = not used
RX B = ESC signal output
RX C = can be used as 2nd RC voltage input
RX 1 = Satellite 1
RX 2 = Satellite 2